1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article2003 Lexus GS 300 PARK/ NEUTRAL POSITION SWITCH MALFUNCTION
download Park/neutral position switch detects the shift lever position and sends signals to the ECM. The ECM receives signals (P, R, N, D, 4, 3, 2 and L) from the park/neutral position switch. When the...
View Article1992 Lexus LS 400 Throttle Position Sensor: Adjustments
download Throttle Body And TPS – Remove throttle body, refer to COMPONENT REPLACEMENT AND REPAIR PROCEDURES. Throttle Stop Screw – Check that there is no clearance between throttle stop screw and lever...
View Article2002 Nissan Altima tune up and cleaned the throttle body
download Customer Concern: Tests/Procedures: Potential Causes: Tech Tips: Just did a tune up and cleaned the throttle body and now the idle is hunting up and down. 1. Perform the Accelerator Pedal...
View Article2000 Honda Accord DX THROTTLE BODY CLEANING
download SYMPTOM When the engine is first started after the vehicle has sat overnight, customers may “feel” the release of the throttle plate through the accelerator pedal. Some describe it as a...
View Article1998 GMC C 1500 Throttle Position Sensor Description and Operation
download DESCRIPTION The Throttle Position (TP) sensor is a potentiometer. The TP sensor is connected to the throttle shaft on the throttle body. By monitoring the voltage on the signal line, the VCM...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article2003 Saturn L300 P2119- THROTTLE CLOSED POSITION PERFORMANCE
download The throttle actuator control (TAC) module contains a direct current actuator motor controlled by the ECM used to move the throttle plate (in either direction) and two throttle position...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article1999-2003 Chevrolet Silverado Revised Steering Wheel Position Sensor or...
download revise the Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement procedure in the Variable Effort Steering (1998-2001 model years) or Steering Wheel and Column (2002-2003...
View Article
More Pages to Explore .....